This is the Minimus 32 which is powered by more expensive Atmel ATMEGA32U2 AVR USB Controller.
New Instruction Manual: http://www.minimususb.com/minimus_v14.pdf
We have tested this and it works prefectly. It is very easy to program
and can be updated at any time without fuss. Unlike other poorly designed AVR Kits,
all the IO's are accessible, there are power and status LED's
and includes a real USB male connector for easy plug and play action.
Presenting Minimus 32 AVR USB, a high quality production grade
AVR USB Development Unit that is clean in design,
low in cost and readily available to resellers around the globe.
There are hundreds of projects available for the AVR USB hobbyist
looking for a powerful yet cost effective solution.
Works with Open Source LUFA USB firmware library and Open Source LibUSB software library.
The Minimus 32 AVR USB is powered by an Atmel ATMEGA32U2
that is pre-programmed with the bootloader
which allows code to be programmed inside the chip without any external programmer,
just download the FLIP software from Atmel's web site and load your HEX code.
To enter the bootloader mode you should simply press and hold HWB button,
then press and release the RST button.
•22 Programmable I/O Lines
•1024 Byte SRAM
•1024 byte EEPROM
•16 MIPS Throughput
•USB 2.0 High Speed
•5V USB Powered
•16MHz Quartz Crystal Oscillator Circuit
•3 x Power / Status LED's
•Male USB Connector - No Cable Required
•Access to all IO's
•Easy Program / Update with Atmel FLIP (Flexible In-system Programmer)
•Robust HW/Reset Buttons (Simple Once-Only Operation When Programming)
•Full LUFA Compatability
•Full LibUSB Compatability
•Simple Plug n Play
•Atmel FLIP Software Drivers: http://www.atmel.com/dyn/products/tools_card.asp?tool_id=3886
•Software Compatible With Windows 9x / Me / NT / 2000 / XP / Vista / 7 and Linux.
•High Quality production quality at the famous Xecuter factory.
•If you have x64 driver problems use these - http://www.minimususb.com/minimus_x64_drivers.rar
Here are some useful AVR USB Development Websites:
Note: The Minimus 32 AVR USB uses a larger Atmel 32k controller
than the Minimus AVR USB so you will need to run at least Atmel Flip v3.4.2
and all codes must be compiled as ATMEGA32U2.